Once the glass components of the rotary evaporator absorb dust and dirt, it not only affects the performance of the instrument, but also shortens the service life. More seriously, it will directly affect the experimental results. Therefore, regular dust removal and cleaning of the glass components is an important part of maintenance and maintenance.
  The glass has good transparency, certain mechanical strength, chemical stability, thermal stability and good insulation properties.In addition to condensers and receiver bottles, many joints, valves, plugs, etc. on rotary evaporators are also glass products.Pay attention to the following aspects of the cleaning of the glass parts of the rotary evaporator:

1.General equipment can use a brush to brush off impurities from the outside to the inside with water or soap, and then rinse the inner wall two or three times with distilled or deionized water.Care should be taken to protect the grinding mouth when scrubbing glass equipment with grinding.  
2.For glass instruments that are not easily brushed with a brush or that are not cleaned with a brush, usually use a detergent to pour or inhale into a container, pour it out, and then pour it out with tap water and deionized water.

3.The sand core glass filter must be cleaned immediately after use. Dissolve the surface precipitate with a suitable detergent according to the sediment in the sand core, rinse with distilled water, dry at 110 ° C and store in a dustproof cabinet.  
We specialize in rotary evaporator, and the popular products of small volume rotary evaporators are: RE-201D (2L rotary evaporator), RE-501 rotary evaporator (5L rotary evaporator).Large scale rotary evaporator includes:R-1020(20L rotary evaporator),R-1050(50L rotary evaporator) and so on.