Mini rotary evaporator also called micro rotary evaporator,such as RE-201D rotary evaporator, RE-301(3L rotary evaporator) , RE-501(5L rotary evaporator). They are consist of mechanical, glass and Constant temperature water bath three parts. Installation is simple and convenient, specific procedures are as follows:
1. Put the rack on the table smoothly, in case of uneven, can adjust the screws in four hard rubber feet under the base-plate

2. Put the vacuum gauge rod mounted on the stainless steel pole, let the vacuum gauge face up to the installer, and then tighten the nut at both ends.

3. Set the motor away from the chassis 48cm, slanting rightwards to about 25 degrees, and tighten the screws of all parts.

4. Fixed the frequency converter on stainless steel frameand then plug five core plug.

5. Fixed condenser flange using the retaining clips. Condenser is vertically, each pipe joint backwards.

6. Insert the feeding tube into the bottle connected the condenser.

7. Install the evaporation flask and receiving flask joint with bottle clamp.

8. Placed the water bath  under the receiving flask and add clean water to 2/3 (Tap water to be placed 1-2 days).

9. Exhaust pipe of condenser  connected to vacuum pump with a vacuum tube, the other ends connected to the cooling chiller.